- 您现在的位置：买卖IC网 > Sheet目录633 > PS12013-A (Powerex Inc)MOD IPM 3PHASE IGBT 1200V 5A
MITSUBISHI SEMICONDUCTOR <Application Specific Intelligent Power Module>
PS12013-A
FLAT-BASE TYPE
INSULATED TYPE
Fig. 4 OUTPUT CURRENT ANALOGUE SIGNALING
LINEARITY
Fig. 5 OUTPUT CURRENT ANALOGUE SIGNALING
“DATA HOLD” DEFINITION
5
V C
V C –
4 min
max
V C – (200%)
V DH =15V
V DL =5V
T C = – 20 ~ 100?C
500 μ s
3
V C0
0V
V CH (5 μ s)
V CH (505 μ s)
2
V C +(200%)
r CH =
V CH (505 μ s)-V CH (5 μ s)
V CH (5 μ s)
1
Analogue output signal
data hold range
V C +
Note ; Ringing happens around the point where the signal output
voltage changes state from “analogue” to “data hold” due
0
–400 –300 –200 –100
0
100 200 300 400
to test circuit arrangement and instrumentational trouble.
Therefore, the rate of change is measured at a 5 μ s delayed point.
Real load current peak value.(%)(I c =I o ! 2)
Fig. 6 INPUT INTERLOCK OPERATION TIMING CHART
Input signal V CIN(p) of each phase upper arm
0V
Input signal V CIN(n) of each phase lower arm
0V
Gate signal V o(p) of each phase upper arm
(ASIPM internal)
Gate signal V o(n) of each phase upper arm
(ASIPM internal)
Error output F O1
0V
0V
0V
Note : Input interlock protection circuit ; It is operated when the input signals for any upper-arm / lower-arm pair of a phase are simulta-
neously in “LOW” level.
By this interlocking, both upper and lower IGBTs of this mal-triggered phase are cut off, and “F O ” signal is outputted. After an “input
interlock” operation the circuit is latched. The “F O ” is reset by the high-to-low going edge of either an upper-leg, or a lower-leg input,
whichever comes in later.
Fig. 7 TIMING CHART AND SHORT CIRCUIT PROTECTION OPERATION
Input signal V CIN of each phase
upper arm
Short circuit sensing signal V S
0V
Gate signal Vo of each phase
0V
S C delay time
upper arm(ASIPM internal)
Error output F O1
0V
0V
Note : Shor t circuit protection operation. The protection operates with “F O ” flag and reset on a pulse-by-pulse scheme. The protection by
gate shutdown is given only to the IGBT that senses an overload (excluding the IGBT for the “Brake”).
Jan. 2000
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
PS12014-A
MOD IPM 3PHASE IGBT 1200V 10A
PS12015-A
MOD IPM 3PHASE IGBT 1200V 15A
PS12017-A
MOD IPM 3PHASE IGBT 1200V 25A
PS12018-A
MOD IPM 3PHASE IGBT 1200V 25A
PS12032
MOD IPM 3PHASE IGBT 1200V 5A
PS12033
MOD IPM 3PHASE IGBT 1200V 5A
PS12034
MOD IPM 3PHASE IGBT 1200V 10A
PS12036
MOD IPM 3PHASE IGBT 1200V 15A
相关代理商/技术参数
PS-120-13P-C
制造商:MEANWELL 制造商全称:Mean Well Enterprises Co., Ltd. 功能描述:120W Single Output Power Supply or Battery Charger
PS12014-A
功能描述:MOD IPM 3PHASE IGBT 1200V 10A RoHS:否 类别:半导体模块 >> 功率驱动器 系列:- 标准包装:15 系列:SPM® 类型:FET 配置:三相反相器 电流:1.8A 电压:500V 电压 - 隔离:1500Vrms 封装/外壳:23-DIP 模块
PS12015
制造商:POWEREX 制造商全称:Powerex Power Semiconductors 功能描述:FLAT-BASE TYPE INSULATED TYPE
PS120-15
制造商:Banner Engineering 功能描述:Power Supply, 120VAC Input, 15VDC @ 1 Amp Output, 8 Pin Octal Socket Connection
PS12015-A
功能描述:MOD IPM 3PHASE IGBT 1200V 15A RoHS:否 类别:半导体模块 >> 功率驱动器 系列:- 标准包装:15 系列:SPM® 类型:FET 配置:三相反相器 电流:1.8A 电压:500V 电压 - 隔离:1500Vrms 封装/外壳:23-DIP 模块
PS12017-A
功能描述:MOD IPM 3PHASE IGBT 1200V 25A RoHS:否 类别:半导体模块 >> 功率驱动器 系列:- 标准包装:15 系列:SPM® 类型:FET 配置:三相反相器 电流:1.8A 电压:500V 电压 - 隔离:1500Vrms 封装/外壳:23-DIP 模块
PS12018-A
功能描述:MOD IPM 3PHASE IGBT 1200V 25A RoHS:否 类别:半导体模块 >> 功率驱动器 系列:- 标准包装:15 系列:SPM® 类型:FET 配置:三相反相器 电流:1.8A 电压:500V 电压 - 隔离:1500Vrms 封装/外壳:23-DIP 模块
PS1201E
制造商:未知厂家 制造商全称:未知厂家 功能描述: